INTEL 82576 ISCSI DRIVER
|Date Added:||26 December 2011|
|File Size:||24.9 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Downloads for Intel® Gigabit ET Dual Port Server Adapter
Software Loopback Interface 1 Then I can type:. I had to first determine the “interface number” of the NICs from the route print command: Edited by Max Saturday, May 23, Reboot and you should be good.
On the first tab you can set CHAP authentication if needed. In this specific configuration that meant setting vmnic3, vmnic4 iscwi vmnic5 to unused and only add vmnic2 as active.
I knew this by comparing ipconfig results for the names of the interfaces. Add the vmnic if this has not already been done.
Switch to the Storage Adapters section and select the vmhba that correspondents to the vmnic you just configured the vmkernel interface for. Remove From My Forums.
Everything boots as expected. How do I get rid of it?
Can you verify that? Next check in the network adapters list to what vmnic this is linked, in this example vmnic2. I did not configure a default route in the Intel setup utility: Saturday, May 23, Toggle navigation Gabes Virtual World.
The target is configured correctly. A ping to the outside world first attempts on Tuesday, November 4, 5: Of course we can also let system automatically do these by customizing these commands into a script file and run it after completed start.
Learn Which Adapters Support Intel® iSCSI Remote Boot
I was able to delete them manually from the command line. Proposed as answer by Samsonitered Wednesday, November 5, 4: Wednesday, November 23, 9: I insured that my DHCP server gave out no default gateway entry. I had to first determine the “interface number” of the NICs from the route print command:. After pressing OK and a rescan of the vmhba, you should now see isfsi LUN s that have been presented to your host.
Intel ET Quad ports + iSCSI ?? |VMware Communities
Right click the vSwitch, choose properties. By continuing to browse this site, you agree to this use. I ran “route print” and noted the interface number and metric of the route, then added it to the route delete command.
Next add it to corresponding vmhba.