If you already created this directory before and modified any of the samples, your changes will get lost. We will now change to an evironment you may not be used too, the Windows command line. In the first place we need the target board. Always use Unix like slashes to separate directory paths, not Windows like backslashes. A confirmation dialog appears, which unfortunately doesn’t clearly state the risk. If not correct, you may reload the configuration later.

Uploader: Mazujin
Date Added: 9 January 2008
File Size: 67.82 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 42931
Price: Free* [*Free Regsitration Required]

If not correct, you may reload the configuration later.

Creating this directory manually will fix this problem. In a first step the build directory will be prepared.

Each build may have one or more associated application directories. If unsure, click Abort and specify another application directory in the Configurator settings. Click OK to start this build.

Atmel AT91SAM9260 ARM quick start

A confirmation dialog appears, which unfortunately doesn’t clearly state the risk. In the first place we need the target board. This way the correct repository will be loaded. These settings are stored in the Windows repository.


Welcome to AT91SAM Community Discussions

At this point it is important to check, that the configuration is loaded from the correct installation directory. The Configurator allows to have any number of builds, each of which may support completely different targets or may differ in just a single configuration option.

One is in Intel hex format events. Check the log window to make sure, that the udb and the configuration file had been loaded from the current installation directory. The easiest way to create such a directory is to let the Configurator create one. Thus no specific programming hardware is required to program the final application into the on-chip flash memory. The programmer selection can isb ignored.

Start a terminal emulator like Hyperterm Windows default or TeraTerm much better.

Atmel AT91SAM ARM quick start – DP

The last page provides a temporary solution to the currently not existing application wizard. You should now see some output in the terminal emulator’s output window. A tabbed dialog with four pages appears. Remember the log in the main window? The Configurator typically starts with a file selection dialog, from which you can choose a pre-configuration for a specific board. In order to start the uploaded code, enter go 0x in the script window.


Don’t worry, nothing really complicated going to happen. After loading the selected configuration, a component tree and a log window appear in the Configurator’s main window. It depends on your programmer or bootloader software, which one will be usefull.

at91sam usb device like debug console – Welcome to AT91SAM Community Discussions

However, at the time of this writing, only Windows had been fully tested uzb this CPU. Open a command line window, for example by executing cmd. If the wrong repository had been loaded, you can correct this here. It is recommended to stick with the defaults shown.

Finally terminate the Configurator. Check the displayed paths again and click OK.

at1sam9260 In any case make sure, that the Install Directory is located within the Build Directory and also check, that arm-gcc platform has been selected. For now, just continue.